|
|
|
G240GP Pneumatic Grip
* For specimens up to 24 mm (1.2") thick
* Requires 5/8" male post with 8 mm pin
* Wide choice of jaws - including wide samples |
| Model | Description | Thickness (Max) | Clamp Load (100 psi) | |
| G240GP | G240GP Single Pneumatic Cylinder Grip |
|
|
|
Model Number | Jaw Description | Jaw Width | Jaw Height | |
J240GBG100 | Rubber faced Jaws - ideal for monofilaments, wire, film, single fibers, and aluminum samples that are weakened by pinching at the edge of the grip face -two each |
|
|
J240GBG | Rubber faced Jaws - ideal for monofilaments, wire, film, single fibers, and aluminum samples that are weakened by pinching at the edge of the grip face -two each |
|
|
J240GBG80 | Rubber faced Jaws - ideal for monofilaments, wire, film, single fibers, and aluminum samples that are weakened by pinching at the edge of the grip face -two each |
|
|
J240GB | Smooth Surface Jaws - for smooth surfaced materials |
|
|
J240GBP | Serrated - 1 mm deep at 45 degrees for materials that require a ‘bite’ for gripping force. Jaws are hardened and used for paper, aluminum, copper, board, steel wire and soft steel |
|
|
J240GBP80 | Serrated - 1 mm deep at 45 degrees for materials that require a ‘bite’ for gripping force. Jaws are hardened and used for paper, aluminum, copper, board, steel wire and soft steel |
|
|
J240GBW100 | Wave surface Jaws - our corrugated wave surfaces provide a deeper bite for testing slippery objects, textiles, bituminous, fabrics and geotextiles - two each per grip |
|
|
J240GBW | Wave surface Jaws - our corrugated wave surfaces provide a deeper bite for testing slippery objects, textiles, bituminous, fabrics and geotextiles - two each per grip |
|
|
J240GBD | Diamond surface Jaws - aggressive surface for hard sheet materials |
|
|
J240GBV12 | V wedge jaws for grabbing round test bars, wire, tubing and rod - two each - Diameters shown -- min to max - Set of two each |
|
|
|